Product shown: Betotop Special Corten profile for concrete kerbs - 20 m pack (Betotop Special). The other heights, finishes and colours of the Betotop range are available as separate products.

Concrete kerbs do the job, but rarely with elegance: visible joints, uneven heights, dull grey. Betotop is a Corten steel U-profile that slides over the top and instantly turns the kerb into a continuous steel line. Ideal for new builds and renovations alike.

Key features of Betotop

Self-locking, fitted in minutes

The profile clips onto the kerb and stays put: no glue, no screws.

Evens out height differences

Thanks to its 2 m length, Betotop smooths out small level differences between kerbs for a clean, continuous line.

Protects the concrete

Corten steel protects the kerb edge from impacts and extends its life, while developing an attractive rust-brown patina.

Which model should I choose?

• Betotop 50: 200 × 5 × 6 cm U-profile, for concrete kerbs 5 cm wide
• Betotop 60: 200 × 6 × 5.5 cm U-profile, for kerbs 6 cm wide
• Betotop Special: U 60 profile extended by a 20 cm return (200 × 6 × 5.5 + 20 cm) that also clads the visible face of the kerb

Measure the width of your kerbs before ordering.

Where can Betotop be used?

• Garden paths and patios
• Borders and lawns
• Driveways and car parks
• Footpaths and cycle paths
• Pétanque courts
• Public spaces

How do you install Betotop?

1. Clean: remove all dirt from the top and sides of the kerb.
2. Remove the film: peel off the profile's anti-scratch protective film.
3. Clip on: slide the profile over the kerb: it locks in place immediately.
4. Align: line up the successive profiles.
5. Finish: take care over corners and joints.

Technical specifications

Technical documentation

• Technical data sheet (PDF, French)